- Apr 07, 2018 -
Five Tips for Stage Lighting Maintenance
The beautiful stage is where many people would like to arrive. Whether or not you are envious of the brilliant light on the stage of the stars, in fact, the beautiful stage can not be separated from the merits of the lamps. Today we will talk about the maintenance of the stage lighting. Some tips.
1. High temperature
When the luminaire is working normally, the ambient temperature must not exceed 40 degrees Celsius.
When the ambient temperature exceeds 40°C, stop using the equipment immediately.
2. Prevent ultraviolet rays
It is forbidden to look directly at the exposed light bulb to prevent ultraviolet rays from damaging the eyes;
Do not use equipment without a lens and lid;
If the lamp cap lens and other lamp body caps are damaged, please replace them with new ones.
3. Prevent electric shock and high voltage
Persons who make electrical connections must have corresponding qualifications to operate;
Before installation, please make sure that the power supply voltage you use must meet the voltage of the power supply identified by the luminaire and there must be overload or leakage protection;
Each luminaire must be properly grounded and electrically installed in accordance with relevant standards;
It is necessary to disconnect the power of the device when installing and removing light bulbs or replacing fuses;
Do not use in thunderstorms or humid environments
4. Regularly check and clean the lighting
Especially for lamps with fans, the air outlets and air inlets must be cleaned and kept clear. Clean up carefully at least once a month.
5 beam lights to focus on maintenance
Optical components, first with a vacuum cleaner or airbag to gently blow off the surface dust, wipe the particles with odorless tissue paper or cotton cloth soaked in water, remove the dust and residues with cotton cloth or odorless paper impregnated with ethyl propanol, Use distilled water for final cleaning and wipe dry with a soft cotton cloth;
Parts with plated color plates and optical lenses, because the surface of the coating layer is brittle and easily scratched, do not use destructive solvents for cleaning;
Beam lights should be handled gently to avoid collisions, falls, etc.;
Be careful not to use it in places with a lot of dust and sand;
After the performance, use the console to extinguish the foam, and the lamp will not cut off the power, let it continue to work for a period of time (letting the fan inside the lamp continue to work to reduce the temperature inside the lamp body);
After the liquidity performance is finished, it should be installed in a special air box to prevent moisture and shock, and the fixed beam light should pay attention to anti-ash, anti-impact, etc.